MINI SUB 170



 

Exploded drawing

Assembly

All the cabinet panels are cut from 16 mm chipboard or medium density fibreboard, butt-jointed and glued. After that, the openings for the driver and terminals are cut out and any necessary recesses cut.

If a separate Bass amplifier is used and should be installed directly to the housing, the necessary cut outs have to be added to the rear side of the cabinet (in this case the size of the woofer has to be increased to assure the 15 l volume; depending on the used amplifier a separate board between amplifier subwoofer cabinet may also be needed).

If no separate Bass amplifier is used the terminal ST 77 has to installed to the rear panel.

Inner damping

The damping material is loosely pushed into the cabinet. The space immediately behind the bass reflex tube must remain free.

Component parts list for 1 box

Woofer AL 170 - 8 Ohm

1 pc.

Terminal ST 77 (if necessary)

1 pc.

Capacitor 1 Elko 470 µF

1 pc.

Capacitor 2 Elko 330 µF

1 pc.

Damping material Polyester wool

1 bag

Special wood screws 4 x 25 mm

4 pcs.

Countersunk screws 3.5 x 25 mm (if necessary)

4 pcs.

Cable 2 x 2.5 mm²

0.5 m

Cabinet parts list for 1 box

Parts

Size (mm)

Quantity

Material: 16 mm chipboard or MDF

Front

264 x 168

1

Rear panel

284 x 168

1

Top, bottom panel

374 x 168

2

BR-tunnel

300 x 168

1

Side panels

300 x 390

2

Sketch

Crossover