ALTO GENESIS SAT

Art. No. 5971

Construction

In order to simplify the cabinet construction as far as possible, we have done without the chamfers shown in the photo. If you prefer to include the all-round front chamfer, you will need the following information:

Sat: 10 mm; 30°

First of all, the individual boards are cut to size (refer to cutting list), stuck together (butt jointed) as shown in the drawing and firmly clamped for the duration of the drying time using sash cramps or parcel tape. Once the cabinet has been completely built, the cut-outs are made for the bass tube and terminals using a jig-saw. The last job is the surface treatment, i.e. painting, veneering or adhesive film.

Inner damping

A half of a mat is put into each satellite.

Component parts list for 1 box

The kit includes all the components listed here but not the cabinet.

Tweeter	DTW 72 8 Ohm	1 pc.
Midrange driver	W 100 S 4 Ohm	1 pc.
Crossover	Crossover ALTO GENESIS SAT	1 pc.
Terminal	ST 77	1 pc.
Bass reflex tube	BR 6.8 (length 6.5 cm)	1 pc.
Damping material	Polyester wool	1/4 bag
Wood screws	3.5 x 19 mm	4 pcs.
Countersunk screws	3.5 x 25 mm	9 pcs.
Cable	2 x 1.5 mm²	0.5 m

Cabinet parts list for 1 box

Parts	Size (mm)	Quantity
Material: 16 mm chipboard or MDF
Front and rear panel	211 x 128	2
Top and bottom panel	180 x 128	2
Side panel	180 x 243	2

Crossover

Sketch

Characteristics and Sound

Search		Home \| Single Drivers / Accessories \| Kits \| Car-Hifi \| High End \| Industry \| Public Address \|