SOLO 50



 

Exploded drawing version 1 (without ring)

Exploded drawing version 2 (with ring)

Assembly

We suggest two alternative cabinets:
1) simple cabinet with narrow chamfers on the sides
2) more sophisticated design with a ring round the B 200 - 6 Ohm.
Acoustically, there is hardly likely to be any difference. The second alternative is much more complex to build, though.

The base is screwed onto a frame and not glued, to enable you to fit the bass reflex tube.

Inner damping

Four mats of damping material are arranged as shown (see drawing). The mat for the inner channel is cut to the width of the cabinet (22 cm) and pushed into the channel flat. The lower mat is rolled lengthways and wrapped around the bass reflex tube but leaving the opening free.

Component parts list for 1 box

The kit includes all the components listed here but not the cabinet.

Fullrange speaker

B 200 - 6 Ohm

1 pc.
Crossover

Crossover SOLO 50/100

1 pc.
Terminal

High-End-Terminal

1 pc.
Bass reflex tube

BR 25.50 (full length)

1 pc.
Damping material

Polyester wool

2 bags
Woodscrews

4 x 25 mm

6 pcs.
Cable

2 x 2.5 mm²

1.5 m

Cabinet parts list for 1 box

1) Version with ring
Parts Size (mm) Quantity
Material: 19 mm chipboard or MDF
Rear panel 900 x 260 1
Side panels 900 x 262 2
Front 900 x 222 1
Top, bottom panels, frame 262 x 222 3
Partition panel 203 x 222 1
Rear channel panel 200 x 222 1
Mounting panels 280 x 222 2
Brace 100 x 222 1
 
Material: 38 mm chipboard or MDF
Mounting ring D = 250 1
 
Material: Triangular ledge
Braces 563 x 25 x 25 2
 
 
2) Version without ring
Parts Size (mm) Quantity
Material: 19 mm chipboard or MDF
Front, rear panels 900 x 260 2
Side panels 900 x 262 2
Top, bottom panels, frame 222 x 262 3
Partition panel 222 x 203 1
Rear channel panel 222 x 200 1
Brace 222 x 100 1

inner damping

Version 2 (with ring)

Version 2 (with ring)

Version 1 (without ring)

Crossover