Art. No. 5940
Construction
In the lower part of the cabinet, you can see the tunnel, made up of the base and an upper board. At the top of the cabinet, behind the cut-out in the baffle for the mid- to high-range unit, is the enclosure required for the mid-range cone, made up of two wooden boards. Three 8 mm holes has to be drilled into the rear board of the mid-range enclosure for the connection leads. These holes have to be sealed well.
Fitting the F 8 SC into the side is a special feature. The mounting board for the F 8 SC (125 x 87 with a 78 mm cut-out) itself is glued in place from inside behind the square cut-outs in the corresponding side panel. For optical reasons the side panel cut-out must be made extremely accurately. The grille will be fitted into this cut-out after completion of the cabinet.
The crossover unit is placed into the cabinet through the cut-out of the woofer and simply laid into the damping material.
Inner damping
Cut two strips from the damping material around 5 cm wide and 30 cm long and place them longitudinally in the cabinets. An additional 5 cm wide strip is cut to make two strips 10 cm long and these are inserted in the cabinets, after the crossovers have been fitted, above and below the woofer.
Component parts list for 1 box
The kit includes all the components listed here but not the cabinet.
Cabinet parts list for 1 box
| Parts |
Size (mm) |
Quantity |
| Material: 10 mm MDF or plywood |
| Front |
75 x 367 |
1 |
| Side panels |
127 x 367 |
2 |
| Bottom panel |
127 x 55 |
1 |
| Rear panel |
342 x 55 |
1 |
| Top panel |
117 x 55 |
1 |
| Bass reflex channel |
100 x 55 |
1 |
| Midrange rear panel |
155 x 55 |
1 |
| Midrange bottom panel |
30 x 55 |
1 |
| Mounting board woofer |
125 x 87 |
1 |
|
