SOLO Eckbox

Construction

The boards are cut to size, adapted and glued as shown in the drawing.
The fabric is applied to the ring using an old iron and hot-melt glue or stapled in place. The ring can then be attached to the front panel using the frame plugs.
No external terminal connections have been included as these cabinets are generally placed right up against the wall. Instead, just drill through the cabinet at a suitable place and feed the cable through the hole.
You will find additional hints on construction in the Oct. 2003 issue of "Selbst ist der Mann".

Inner damping

The 8 mats of damping material are uniformly distributed in the entire cabinet.

Component parts list for 1 box

Fullrange speaker	B 200 6 OHM	1 pc.
Crossover	see circuit diagram
Damping material		4 bags
Wood screws	4 x 25 mm	6 pcs.
Material for speaker covers	width 50 cm	0,5 m
Frame dowels		4 sets
Cable	2 x 1,5 mm²	1,5 m

Cabinet parts list for 1 box

Parts	Size (mm)	Quantity

Material: 19 mm MDF or chipboard
Front	1500 x 550	1
Side panels	1500 x 362	2
Top and bottom panels	324 x 324	2
Braces	155,5 x 100	6
Braces	229 x 100	3

Material: 10 mm MDF or chipboard
Grille board	D 340	1

Crossover

Sketch

Characteristics and Sound

Search		Home \| Single Drivers / Accessories \| Kits \| Car-Hifi \| High End \| Industry \| Public Address \|