CT MAIN 100

Construction

The cabinet body uses 16 mm boards. First of all, cut the holes in the boards and apply the bevels. This can be done using an electric jigsaw or hand-held circular saw set to the required angle. Once the cabinet has been completed, apply the milling work for the loudspeaker. Finally, fit the cones.

Since the cabinets are relatively small, it is hardly possible to mount the crossover inside the housing. It can, however, simply be wrapped in damping material and placed inside the speaker if the rear wall is not removable.

Inner damping

One mat of damping material is loosely pushed into the cabinet.

Component parts list for 1 box

The kit includes all necessary components (see list below). Cabinet parts are not included.

Tweeter:	G 25 ND 8 Ohm	1 piece
Woofer:	W 100 S 4 Ohm	2 pieces
Crossover:	Crossover CT MAIN 100
Terminal:	ST 77	1 piece
Damping material:		? bag
Countersunk screws:	3,5 x 25 mm	16 pieces
Cable:	2 x 1,5 mm²	1 m
		................

Cabinet parts list for 1 box

Parts	Size (mm)	Quantity

Material: 16 mm chipboard or MDF
Front and rear panel:	160 x 396	2
Side panel:	178 x 396	2
Top and bottom panel:	178 x 128	2
Brace:	50 x 128	1

Crossover

Sketch

Characteristics and Sound

Search		Home \| Single Drivers / Accessories \| Kits \| Car-Hifi \| High End \| Industry \| Public Address \|