ALTO GENESIS SAT



 

Exploded drawing

Assembly

In order to simplify the cabinet construction as far as possible, we have done without the chamfers shown in the photo. If you prefer to include the all-round front chamfer, you will need the following information:

Sat: 10 mm; 30°

First of all, the individual boards are cut to size (refer to cutting list), stuck together (butt jointed) as shown in the drawing and firmly clamped for the duration of the drying time using sash cramps or parcel tape. Once the cabinet has been completely built, the cut-outs are made for the bass tube and terminals using a jig-saw. The last job is the surface treatment, i.e. painting, veneering or adhesive film.

Inner damping

A half of a mat is put into each satellite.

Component parts list for 1 box

The kit includes all the components listed here but not the cabinet.

Tweeter

DTW 72 - 8 Ohm

1 pc.
Midrange driver

W 100 S - 4 Ohm

1 pc.
Crossover

Crossover ALTO GENESIS SAT

1 pc.
Terminal

ST 77

1 pc.

Bass reflex tube

BR 6.8 (length 6.5 cm)

1 pc.
Damping material

Polyester wool

1/4 bag
Wood screws

3.5 x 19 mm

4 pcs.
Countersunk screws

3.5 x 25 mm

9 pcs.
Cable

2 x 1.5 mm²

0.5 m

Cabinet parts list for 1 box

Parts Size (mm) Quantity
Material: 16 mm chipboard or MDF
Front panel 243 x 160 1
Rear panel 211 x 128 1
Top and bottom panel 164 x 128 2
Side panel 164 x 243 2

Sketch

Crossover

Press

Extract from HiFi Test

"The listening test proved the value of the impressive deep bass qualities ...." "While the satellite speakers provided the necessary crystal-clear mid- to high-range fill-in ...." "The testers at HiFi Test only have one recommendation to make Buy!"

Verdict: very good

Press

Extract from Audio

"A masterly performance - the bass system produced such deep, deep bass attacks with such amazing clarity from its bandpass cabinets that it ended up with no less than 50 points."

Value for money: very good